AC403: Interference

With all analogue monitors/wireless devices there is always a chance that eventually some interference may occur, this does not mean that your monitor is faulty.

It may be something in or around your home that you are unable to change such as neighbours WIFI etc. Have you tried using it in a friend or relatives home to see if the interference is the same or better?

To prevent interference please make sure that the batteries in the Parent Unit are fresh and fully charged for best reception. If you have not changed your batteries within the last 6 months it would be advisable to do so.

The cells depreciate over time as they are constantly charged and can give a false reading and also contribute to interference – please see below for “Rechargeable Battery Information”:

Rechargeable batteries

This issue could be due to the holding charge within your Rechargeable Batteries in the Parent Unit.
The Parent Unit uses NiMh Rechargeable Batteries only.

These batteries need to be used correctly, if they are over charged the battery cells that hold the charge can be destroyed and the battery will not fully charge, the Parent Unit can still show the ‘Full Battery Icon’.

It is vital, for optimum performance from this type of battery, to charge for 15hrs before their first use.
To ensure the longevity of your battery life you need to fully charge and fully discharge periodically, this keeps the cell life to a maximum.

If you are unsure about your battery performance, please replace the Rechargeable Batteries with 4 x AAA NiMh (available from all good retailers) approximately every 6 months.

Have you tried changing the channel on your monitor? The AC403 has 8 channels to choose from and changing the channel can stop the interference, please see below for information on how to do this:

How to change the channel on your Parent Unit

Turn both parent and nursery unit ON

Press and hold the SELECT button on the Parent Unit until you hear a beep and the display shows C1 to C8

Press the UP or DOWN arrow buttons to select another channel

Press SELECT to confirm the channel

Press the EXIT button on your monitor which saves your settings
PLEASE NOTE - You must carry out the last 2 steps to save your new setting or your monitor will revert to the previous setting

To improve your monitors performance please also try the following:

· Always keep your monitor away from other wireless devices

· Never operate your monitor in close proximity to a microwave, cordless or mobile phone

· Reorient or relocate your monitor to optimize reception, place away from WIFI or Router

· Never place a GSM cell phone or other Radio Frequency emissions device in close proximity or in contact with your monitor