This process is the same whether you are replacing the Sensor Pad, reconnecting the original Sensor Pad due to a loss of connectivity or if the connection is lost when changing the CR3032 cell battery
• Power OFF the Parent & Camera Unit
• Remove the CR3032 battery from the original Sensor Pad
If you are replacing the original Sensor Pad - place the original battery & Sensor Pad aside to prevent any mix up - the CR30302 battery must be removed
• Place CR3032 battery into the Sensor Pad you are connecting
• Power off the Parent & Camera Unit – remove batteries from both units for approx. 20 seconds and then replace
• Power ON the Camera & Parent Unit and press the settings icon on the Parent Unit screen
Please Note: you have approx. 15 seconds to carry out the following steps before the alarm sounds. If this happens you will need to start again
• Press the pairing icon (bottom left icon) to enter pairing menu
If there is a red bin in the top row press this and a red TICK icon will show
• Press the red TICK icon to delete the red bin
• Press and hold the blue cross until it turns to a blue circle
• The green power light on the Parent Unit will flash slowly to indicate connecting
• Once connected the red bin will appear again to indicate the Sensor Pad is connected
If there is no red bin icon in the top row press and hold the blue cross until it turns to a blue circle
• The green power light on the Parent Unit will flash slowly to indicate connecting
Once connected the red bin will appear again to indicate the Sensor Pad is connected
Comments
0 comments
Article is closed for comments.