AC1300: How to: connect a replacement Parent and/or Nursery Unit to your existing Monitor

AC1300 - How to Connect your Parent Unit and/or Nursery Unit - whichever is replaced:

For advice on how to install the battery provided separately - do not remove the yellow film - see attached PDF below

Switch the Nursery Unit & Parent Unit OFF

Switch the Nursery Unit ON

Quickly press & release the power button/wing 4 times or until the Nightlight on the Nursery Unit  flashes indicating in connection mode

Switch the Parent Unit ON

Once the Angelcare logo disappears off screen PRESS & KEEP HOLD of the Zoom Button on the Parent Unit

Whilst still holding down the Zoom Button quickly PRESS & RELEASE the Power Button on the Parent Unit

Please Note: Do not press the power button for too long as this will switch the Parent Unit OFF and you will need to begin again

Now release the Zoom Button and you will see the video display on screen